High efficiency Flat Belt Conveyor

Whether the Telescopic Belt Conveyor can run normally and smoothly after installation mainly depends on the installation accuracy of the drive device, the roller and the tail wheel. Whether the center of the telescopic Belt Conveyor bracket coincides with the center line of the drive device and the tail wheel.

Drive installation:
The theodolite can be used to make a mark between the nose (driving device) and the tail (tail wheel) of the machine so that the center line between the nose and the tail is connected in a straight line. Using this method to pay off the line can ensure a higher installation. precision.
The installation drive device is mainly composed of motor, reducer, drive roller, bracket and other parts.
First, we assemble and place the drive drum and the bracket on the embedded board, place a steel backing plate between the embedded board and the support, and level it with a spirit level to ensure that the levelness between the four points of the support is less than or equal to 0.5mm.
Then, find out the center line of the driving drum, place the line weight on the center line, and adjust the longitudinal and transverse center lines of the driving drum to coincide with the basic center line.
Installation steps of telescopic belt conveyor
When adjusting the elevation of the drive drum, it is also necessary to consider reserving a certain margin for the adjustment of the elevation of the motor and reducer. Since the connection between the motor and the reducer has been adjusted on the bracket when the equipment is manufactured, our task is to align, level, and ensure the coaxiality between the reducer and the driving drum.
When adjusting, take the driving drum as the benchmark. Since the connection between the reducer and the driving drum is an elastic connection of nylon rods, the accuracy of the coaxiality can be appropriately relaxed, and the radial direction can be adjusted to less than or equal to 0.2mm, and the end face is not greater than 2/1000.
Installation of tail wheel and roller:
Installation of the tail wheel The tail wheel consists of a bracket and a drum, and the adjustment steps are the same as the driving drum.
Installation of outriggers, intermediate frames, idler brackets, and idler rollers Most of the outriggers of the belt conveyor are H-shaped, and their length and width vary according to the length and width of the belt, the amount of belt transportation, etc.

Installation of accessories and safety devices:

The installation of accessories can only be carried out after the strap is placed on the bracket. Accessories include empty section cleaners, head cleaners, anti-deviation switches, belt tensioning devices, etc.

After the operation of the above methods and steps, and to ensure a certain range of accuracy, through the no-load and load test run, forward and reverse direction test run, and adjust the belt deviation, you can run smoothly and safely.